Precision conductive plastic displacement sensor installation and use instructions

　　Introduction: Conductive plastic displacement sensor is a non-wirelessly wound potentiometer with a linear relationship between voltage output and axis rotation Angle or linear displacement, which is characterized by high precision, high life, high smoothness and high resolution. It can be used as position feedback, position detection, level adjustment, etc. The sensor structure is mainly composed of resistance element, shaft, brush, shell, cover and so on. Rotary sensors have two kinds of single and double, they are installed in the same form, divided into nut fixing (such as WDD32 type), screw fixing (such as WDD35D type), the electrical signal is generally in the form of a terminal. The installation form of the straight slide sensor is generally fixed by screws, and the electrical signal is drawn in three forms: wiring pile type (such as: WDM14 series), socket type (such as CFY electronic ruler series) and wire type (such as CWY series).

　　Two, wiring method and principle: three terminals or red, yellow, blue three lines corresponding to the label mark 1, 2, 3 respectively: 1 is the input end; 2 is the output end; 3 is grounded. (Please note: if the leading end 2 is connected to the wrong line will burn the sensor) The axis from the precision conductive plastic potentiometer, method 1 end to 3 end Angle rotation or linear displacement when the resistance value changes, by the 2 end according to the linear law of high-precision output, while through the conversion circuit to convert the resistance value change into a signal display.

　　Third, the use of voltage description:

　　The sensor uses DC voltage, plus the rated voltage at the 1 and 3 terminals (two fixed terminals).

　　U - Rated voltage (V)

　　P - Rated power (W)

　　R - Nominal resistance (Ω)

Read recommendations:

4-shelf wire storage rack wholesale

2 tier steel wire shelf Processing

When assembling lightweight shelves, the following points need to be noted