Scheme storage shelf

　　When designing the storage shelf in the scheme, it should be reasonable. When designing the storage shelf structure of the integrated stereo warehouse, especially pay attention to the following two kinds of bad load composition: support under full load of the whole warehouse when the wind load works; The support under which the whole reservoir is fully loaded when the level earthquake disaster is effective. In addition, the distribution of goods in the warehouse shall be fully considered, that is, when one side of the warehouse is full and the other side is full, the basic stress analysis of the warehouse shall be carried out. Although there is a basic theory of goods distribution and storage in the warehouse; Although it is required in the operating instructions of the warehouse that the distribution and storage of goods in the warehouse should be as symmetrical as possible, the major tasks must be taken into account when calculating the design scheme.

　　The selection of storage shelf form is also a very important problem of integrated automated warehouse. Storage shelves are divided into integrated electric welding storage shelves and assembled storage shelves according to their structural forms. According to the standard, the large vertical error of the upright of the assembled storage shelf shall not exceed 1/120 of the full height, while the vertical error of the upright of the integrated storage shelf shall not exceed 1/1000 of the full height, and the absolute vertical deviation shall not exceed 11mm. Therefore, it can be seen that the production, processing and installation precision of the integrated storage shelf is higher than the combined shelf. The key to the selection of storage rack form in integrated automated warehouse is the measurement of various loads and the appearance specification of the warehouse. Because the assembled storage shelf has great variability at the installation and construction site, the integrated electric welding storage shelf is often used in the design scheme of the integrated warehouse. The materials for the upright pole of the integrated electric welding storage shelf also include pipe, rectangular pipe, round steel and other raw materials. According to the characteristics and index values of aluminum profiles, square steel pipes are suitable.

Read recommendations:

Metal Rolling Utility Cart / Double-sided Display Cart with Hangers / Wire Storage Cart with Mesh P

white wire shelving unit Solution

Introduction to the characteristics of supermarket shelves.wire storage racks for pantry