Storage shelf production requirements

　　The quality of warehousing shelves has a great impact on the warehousing safety system. In today's high -speed development, everyone has a modern logistics. The degree of attention is becoming more and more important, the demand for the right shelves has also increased significantly, the scope of the use of the shelves has continued to expand, and the provision of the shelves will continue to increase, forming a brutal shelf market. However, due to the low standards of the shelf industry, there is no standard industry standard, so the following aspects must be achieved to avoid affecting the safety of the shelves. The warehouse shelves must follow the following rules to ensure the quality and use of the shelves.

　　After the storage shelves are assembled, the accuracy must meet the requirements of the following: the error of the height of the warehouse section is ± 2mm, the error of the width is ± 2mm, and the uneven error of the bottom plate is ± 0.5mm. After welding, the accuracy of the beam of the warehouse shelf must meet the requirements of the following requirements: For the vertical level of the three -pillar claw cable of the column card and the baseline of the shelter beam, the length of the beam should be less than equal to 2mm. As for the column card and beams The welding position should be kept ± 1mm error.

　　Overall device request of the warehousing shelves: The stroke of the length of the lane lane of the warehousing shelves is within 6mm. The distance of the base distance is ± 2mm, and the same lanes are not greater than 5L in a column of racks.

Read recommendations:

Gray box

microwave stand countertop Solution

Storage shelves.metal TV stand for 75 inch TV